Loading... Please wait...


Yamaha R1 Tail fitting guide

Click image for more detail Image 1
  • Image 1


Product Description

1. Remove the 8 pop studs from undertray, (just push in the middle)
2. Remover the front seat 2x bolts (lift the rear corners of seat)
3. Remove the rear seat and 1x Philips head bolt.
4. Remove the tail unit front fixing bolts.
5. The fairing can now be removed.


UNDERTRAY FIXINGS


6. Offer up the new undertray inside the bodywork and check the fit.
7. Fix the undertray in to the fairing using the nuts and bolts provided.
8. Using a hot glue gun, carefully glue the nuts to the fairing mounting tabs,
be careful not to get glue on the bolt threads. so you can remove the bolts later.
9. When the glue dries you can remove the bolts.


MAKE SURE YOU ARE HAPPY WITH THE FIT BEFORE YOU START CUTTING


LIGHT REMOVAL

10. Unplug the rear light and indicators
11. Remove the rear tail light and its fixing bracket,2x pop studs on frame and
1x pop stud under rear guard.
12. Remove the light from the housing (3x Philips screws)


Cut the light bracket down as per photo and re mount it on to bike frame.


CUTTING & FITTING


13. Cut the standard undertray down both sides so the original faring fixings are gone then cut
across the middle of the tool box as per photos. Keep the rear toolbox fixings in place.
14. Replace outer bodywork and fix in place using the original bolts.
15. Offer up the new undertray and fix into place using the 8x bolts provided, Push the bolts into
place and do them up slowly so you don’t push the nut of the inside tab.
16. Do not tighten the nuts up 1 at a time, make sure you can get all of them started before you
tighten them up. Some holes may need slotting to aid fitting.
17. Mount number plate.


The led tail lights wiring is as follows

 

Yamaha Bike Tail light colours

Black = Earth

Yellow = Brake

Blue/Red = Tail

 

Led Tail lights

Black = Earth

Red = Brake

Yellow = Tail light

 


To Fit the mini Indicators you need to just glue them in place using a hot glue gun or trim the wing off the nut first.

 

 

Remove Seat fixings and forward fairing bolts.

cimg0192.jpg

Remove rear fairing bolts, shows trim line in tool box.

cimg0193.jpg

Remove pop studs ( just push in the middle )

Shows inner trim line.

cimg0194.jpg

Remove the tail light and trim the mount down.

cimg0199.jpg

Tail light support shown fitted, this keeps the top fairing mount in place.

cimg0200.jpg

Find Similar Products by Category

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

Currency Calculator

Add to Wish List

Click the button below to add the Yamaha R1 Tail fitting guide to your wish list.

Recently Viewed